V2000-c Rfid Access Control User Manual Jun 2026

Note: Verify label on your unit for exact terminal names and polarity.

Verify your relay wiring. If you are using a magnetic lock (Fail-Safe), ensure it is wired to NC and COM . If using an electric strike (Fail-Secure), ensure it is wired to NO and COM . Also, check if the relay opening time is accidentally set to 0 seconds. Issue: Lost Master Programming Code.

In programming mode, press 1 + Slot ID + # + 4-Digit PIN + # . V2000-c Rfid Access Control User Manual

Installing and configuring the V2000-C RFID access control system requires careful planning and attention to detail. Here are the general steps involved in installing and configuring the system:

A: 500 users (500 RFID cards or 500 PIN codes, or a mix). Note: Verify label on your unit for exact

This usually indicates insufficient voltage or amperage from the power supply. Ensure the power supply outputs a stable 12V DC with at least 1.5A to 2A of current.

Connect the positive wire of the lock to NO , the negative wire of the lock to GND , and bridge COM to +12V . When power is lost, the lock remains secured. If using an electric strike (Fail-Secure), ensure it

Always disconnect the power supply before wiring the device to prevent short circuits. Wire Color Codes and Functions