Verify the rail angle matches the staircase pitch using your inclinometer. Drill pilot holes into the stair treads through the bracket mounting holes. Secure the brackets using the provided heavy-duty lag screws. 4. Drive Chassis and Seat Installation
Mark the pilot holes through the bracket base plates onto the steps. Drill pilot holes into the stair treads.
Program the wireless wall remotes by holding down the up and down buttons simultaneously until the LED blinks. Test the call-and-send function.
Verify that the charging indicator light on the transformer turns green or amber, signaling that power is reaching the track. 7. Testing, Calibration, and Safety Checks
Position the rail at the correct distance from the wall (typically 5 to 7 inches, depending on the staircase configuration). Use a level to ensure the rail is straight and not bowing. thyssenkrupp levant stair lift installation manual
Once the rail is anchored, the mechanical drive components can be integrated. Step 4.1: Sliding the Carriage onto the Rail
Ensure at least 18" to 20" of clearing distance at the bottom of the stairs for safe parking and boarding. Key Installation Steps
Gently press the sensitive surfaces on the footrest and carriage covers while the lift is moving. The unit must stop instantly to prevent pinching or crushing hazards.
Test both wireless remote controls to ensure the call/send functionality works flawlessly from both landings. 7. Troubleshooting Common Installation Errors Potential Cause Resolution Key switch is off or batteries are disconnected. Verify the rail angle matches the staircase pitch
: Snap the rail brackets into the rail channels. Secure them to the stair treads using 2 to 5 screws per bracket .
at the top and bottom of the rail to prevent the carriage from accidentally driving off the track. Step 4.2: Installing the Seat Assembly Mount the seat post onto the carriage interface.
Mount the wall charger near your power outlet. Run the low-voltage cable from the charger to the terminals on the rail's end cap.
To preserve the longevity of your ThyssenKrupp Levant stair lift, perform the following preventative maintenance every six months: Program the wireless wall remotes by holding down
If you publish or use such a paper, add this disclaimer:
Two wireless infrared or radio-frequency call/send remotes. Required Tools Socket wrench set (metric and standard) Allen/Hex key set Electric drill with wood/concrete drill bits Spirit level (torpedo and 4-foot levels)
If you encounter any mechanical failures or error codes not covered in this guide, consult a certified ThyssenKrupp accessibility technician to avoid voiding your warranty or compromising user safety.