Plug the heavy-duty data connectors into the designated ports on the respective control boards. Secure the cable using internal strain-relief clamps. Peripheral and Access Control Integration
A great installation includes teaching. Walk operators through normal operation, emergency procedures, and simple maintenance tasks: cleaning glass and seals, lubrication points, how to reset a jam, and how to recover from a power loss. Deliver a package: as-built drawings, cable schedules, configuration backups, and a spare-parts list.
What (RFID, biometric, barcode) are you integrating?
| Error Code / Symptom | Probable Cause (from manual) | Solution | | :--- | :--- | :--- | | | Motor thermal overload tripped or power supply fuse blown. | Wait 10 minutes for reset or replace 5A fuse on the power board. | | Flaps close on user (hitting shin) | IR beam "B3" misaligned or dirty. Lane too wide (over 1000mm). | Clean the IR lens with microfiber cloth. Re-run Auto-Tune calibration. | | Continuous alarm sound | Floor vibration causing sensor bounce. | Install rubber vibration dampening pads under the pedestal (not included, but recommended in appendix C of manual). | | Unit doesn't respond to card reader | Wiring polarity reversed on J5-J8 (Tip vs. Ring). | Swap wires on the "Card In" and "Card GND" terminals. | | Flaps open slowly | Hydraulic damper failure or low temperature (<0°C). | Refer to manual for damper replacement (Part # GSF-DMP-01). Add lane heater kit. | gunnebo speedstile fl installation manual
Remove the factory-installed jumper from the emergency input terminal. Connect a Normally Closed (NC) volt-free contact from the building fire panel. Opening this circuit drops all hold-voltage, allowing the glass wings to open instantly for evacuation. 5. Mounting the Glass Wings
Before proceeding with the installation, ensure you have:
The you are integrating with
relies on infrared sensors. Ensure the sensors are clean and aligned properly to detect pedestrians and prevent premature closing. 5. Configuration and Commissioning
Obstruction sensors must trigger an immediate reopening of the leaves if a person or object stops inside the lane during the closing cycle. If you need help configuring specific settings, tell me: Which control board version is inside your gate? What type of access control reader are you wiring? Are you configuring a single lane or a multi-lane array ?
Do not install directly on floating floors or unsecured tiles. Electrical and Data Conduit Layout Plug the heavy-duty data connectors into the designated
Tighten the clamping bolts evenly in a cross pattern to a torque of
, comprehensive site preparation is necessary. The unit must be installed on a finished, flat, and level floor to ensure the glass panels operate smoothly and align correctly Structural Integrity: