Elapsed trip time (RT), a 12/24-hour clock (CLK), and a stopwatch function.
To clear your DST, TM, AVS, and MXS data before starting a new ride, navigate to any of these screens. Press and hold the for 3 seconds. The odometer (ODO) will not be cleared. 🔋 Battery Replacement Procedure echo j7 cycle computer manual
Note: Some Echo J7 variants label buttons as (A=SET, B=MODE, C=RESET, D=not used). Elapsed trip time (RT), a 12/24-hour clock (CLK),
Press the Set button on the back of the unit to re-enter programming mode. Check your tire sidewall and verify the value against the calibration chart above. The odometer (ODO) will not be cleared
Use to adjust the hours, press Set , then use Mode to adjust the minutes. Press Set to exit. 6. Troubleshooting Common Issues Probable Cause Corrective Action Screen is blank or fading Dead or dying battery. Replace the CR2032 battery. Speed reads constant 0 Magnet/Sensor misalignment. Check that the gap is between 2-4mm and aligned vertically. Sluggish display reaction Operating temperature too low. Computer will return to normal when weather warms up. Inaccurate speed readings Incorrect wheel factor (Cc). Check your tire sidewall and re-program the MM setting. Black screen Left sitting in direct hot sunlight.