Exclusive ((install)) | Ts1162 Installation Manual

Position the bracket against the surface. Use a leveling tool to ensure it sits perfectly horizontal. Mark the pilot holes, drill into the structural supports, and secure the bracket tightly using the heavy-duty screws provided in the hardware kit. Step 3: Mounting the TS1162 Unit

The TS1162's unique housing can be installed directly on a . Ensure the mounting surface is flat, solid, and vertical so the base will not flex when screws are tightened. ts1162 installation manual exclusive

If you need to move water uphill or over a long distance where gravity drainage isn't possible, an optional condensate pump kit can be installed. Position the bracket against the surface

Set your laptop's Ethernet adapter to a static IP within the factory default subnet (typically 169.254.0.X or as specified in your accompanying documentation pack). Step 3: Mounting the TS1162 Unit The TS1162's

: Mount the device at an accessible height (typically 1.2 meters nominal) [1.1]. Ensure the rear optical tamper sensor sits flush against a completely flat, non-flexing wall surface to prevent false tamper conditions.

A: Up to from the Challenger panel or Intelligent Access Controller.